Net-optics 8x1 Regeneration Taps Manual de usuario descargar pdf (Pagina 13)

8x1 Regeneration Taps

Connecting to the Monitoring Devices

1. If you have a ber model, install the appropriate SFP or SFP+ transceiver

modules in the Monitor ports. (You need to install modules only in ports to

which you will be connecting monitoring tools). Push each module in until

you hear a click and see the SFP Present LED above the port illuminate.

2. Connect any Monitor A port to the appropriate monitoring device using an

appropriate cable. The device will monitor Network trafc being received

at Network A port over this cable.

3. Connect any Monitor B port to another NIC on the same monitoring device

using an appropriate cable. The device will monitor Network trafc being

received at Network B port over this cable.

4. Connect other monitor devices to the remaining monitor ports as desired.

All of the Monitor A ports mirror the trafc being received at Network

A, and all of the Monitor B ports mirror the trafc being received at

Network B.

Network A

Network B

Regen Tap

Full duplex

1000

100

Push to

change

mode

Network A traffic to monitoring device

Network B traffic

to monitoring device

Figure 8: Connecting the Monitoring Devices

Note: _______________________________________________________________

On inline models, if trafc is passing between the devices on both sides of

the Network ports but no trafc can be seen on the monitoring ports, the

cables plugged into the Network ports may have TX and RX reversed. To x

this condition, reverse the TX and RX connections on BOTH Network A and

Network B ports. If you reverse the connections on only one of the ports,

trafc will not be able to pass between the devices.

______________________________________________________________________

1 2 ... 8 9 10 11 12 13 14 15 16

Sin comentarios

Net-optics 8x1 Regeneration Taps Manual de usuario Pagina 13