Net-optics 10 GigaBit In-Line Regeneration Taps Manual de usuario descargar pdf (Pagina 14)

10 GigaBit In-Line Regeneration Tap

Troubleshooting

Before contacting Net Optics Technical Support, perform the following checks.

Problem Solution

Power LEDs do not illuminate Check both power cord connections.

Check both power sources for power.

Link Status LEDs do not illuminate Check that you have connected the

network devices correctly (see Figure 4,

page 5). Verify that the TX and RX are not

crossed on the network ports.

Check that the connectors are clean and

rmly seated.

Verify that you are connected to 10 GigaBit

transceivers.

Trafc is passing through the Tap

but not through the Monitor Ports

Check that you have connected the

network devices correctly (see Figure 4,

page 5). Verify that the TX and RX are not

crossed on the network ports.

Check that the connectors are clean and

rmly seated.

Verify that you are connected to 10 GigaBit

transceivers.

Communications are intermittent Check that the connectors are clean and

rmly seated.

Check insertion loss calculations.

Check that you are using the correct ber

cable type (see page 12).

Replace cables with cables known to be

good.

If these checks fail to correct the problem, note the unit’s serial number before

calling Net Optics for assistance and be prepared to describe the installation

scenario and the problem you are experiencing.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Net-optics 10 GigaBit In-Line Regeneration Taps Manual de usuario Pagina 14