Net-optics 10 GigaBit In-Line Regeneration Taps Manual de usuario descargar pdf (Pagina 11)

10 GigaBit In-Line Regeneration Tap

Connecting to Monitoring Devices

Using Net Optics Custom Monitoring Cable

The Monitor Ports of the Regeneration Tap are transmit only. Connect the

Monitor Ports to the receive side of two NICs on the monitoring device.

Net Optics offers a custom “Y” cable with the correct connections for quick

installation. The SC connectors on the Custom Monitor Cable contain Rx

connections only. The Tx connectors do not have ber and provide a safe

cover for laser light.

To connect a Custom Monitoring Cable:

1. Using a Net Optics Custom Monitor Cable (see Figure 5), connect the

single-duplex end to the Regeneration Tap Monitor Port A or B.

2. Connect the twin-duplex end of the cable labeled into the

appropriate monitoring device port to monitor the link (see

Figure 7).

3. Connect the other twin-duplex end to the appropriate monitoring

device port to monitor the link.

4. Repeat steps 1-3 for each monitoring device you wish to connect

to the Regeneration Tap.

Figure 5: Net Optics Custom Monitor Cable

DTE

DCE

To Monitor NIC Rx

To Monitor Port

Rx Disabled

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

Net-optics 10 GigaBit In-Line Regeneration Taps Manual de usuario Pagina 11