Net-optics Link Aggregator Tap 10/100 In-Line to GigaBit with Manual de usuario Pagina 5

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 4
10/100 In-Line Link Aggregator Tap
1
Introduction
Thank you for choosing the most versatile monitoring Tap available today.
Net Optics Link Aggregator Taps are an efciency breakthrough for passively
monitoring multiple full-duplex links. Whether you are a novice or an expert,
this installation guide is designed to help answer any questions and to provide
a quick set-up reference.
Net Optics Link Aggregator Tap provides superior monitoring coverage while
leveraging monitoring resources. Providing trafc from multiple network
links, the Link Aggregator Tap combines up to four full-duplex 10/100BaseT
links (eight half-duplex data streams) into one, two or four GigaBit monitor
ports.
Installing a monitoring device in each segment of the network is often time
consuming and expensive. Restricted by tight budgets, security managers must
make compromises that leave portions of the network exposed to attacks.
Net Optics’ Link Aggregator addresses this challenge by increasing the num-
ber of links covered by monitoring devices already installed.
No Packets Left Behind
The Link Aggregator Tap buffers and scans incoming trafc from the network
ports on a round-robin basis. Buffer size and scan rate is optimized to ensure
that no packets are dropped and there is no bandwidth limitation on incoming
data streams. The buffers and the high bandwidth of GigaBit monitor ports
guarantee that no data is lost during trafc surges.
Security and Visibility
Without an IP address, monitoring devices are isolated from the network,
dramatically reducing their exposure to attacks. However, the monitoring
device connected to the Tap still sees all full-duplex trafc as if it were in-line,
including Layer 1 and Layer 2 errors.
Reliability
For extra uptime protection, Net Optics Taps offer redundant power connec-
tions. Should the primary power source fail, the Tap automatically switches
to the backup power source. Power LEDs on the front of the Tap indicate the
current power source.
Vista de pagina 4
1 2 3 4 5 6 7 8 9 10 ... 15 16

Comentarios a estos manuales

Sin comentarios