Net-optics 96547iTP Manual de usuario descargar pdf (Pagina 15)

iTap GigaBit Dual Port Aggregator

To change the username and password:

1. Change the username by typing the following command:

set username <username>

where <username> is your new username.

2. Change the password by typing the following command:

set password <password>

where <password> is your new password.

3. Record the username and password in a secure location.

To set the iTap IP address:

1. Type set ip <ip address> where <ip address> is the IP address you are assign-

ing to the iTap and press Enter.

For example, typing set ip 10.60.0.100 sets the iTap IP address to 10.60.0.100.

To set the utilization threshold levels:

1. Type set threshold port a <level> where <level> is the percentage of the

available bandwidth at which the utilization alarm for Port A is triggered. Press

Enter.

For example, typing set threshold port a 30 sets the alarm threshold level for

trafﬁ c received on Port A to 30%.

2. Type set threshold port b <level> where <level> is the percentage of the

available bandwidth at which the utilization alarm for Port B is triggered. Press

Enter.

For example, typing set threshold port b 30 sets the alarm threshold level for

trafﬁ c received on Port B to 30%.

Tip! _____________________________________________________________________

You can set the utilization threshold levels at any time from the remote interfaces.

See Chapters 4 and 5 for more information.

__________________________________________________________________________

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Sin comentarios

Net-optics 96547iTP Manual de usuario Pagina 15